4PCs Replacement Analog Joystick for Xbox One Controller – ElecGear Repair Parts 3D Thumb stick Wireless Controller Rocker with T6 T8 Screwdriver Tool Kit for Xbox One, One S, One X and Elite

• Operating System   Xbox One
• Format   Electronics
• [EL4 for Xbox Controller] – 4x replacement analog joystick widely compatible with Xbox wireless controllers: Xbox One, One S and X and Elite Series 1. It is also used in newest Xbox Series S|X controllers. The thumbstick module was made by ALPS. This RKJXV stick controller series comes with 10K ohm trimmer potentiometers [Compatibility] – This version of analog stick comes in light gray bottom plate. It locks in certain direction when not sit in controller cover. It comes with the same 14 prongs structure as PS4 versions. However, they’re slightly different from each other. Please use this EL4 for Xbox. Be noticed: EL4 does not work with older Xbox 360 [Additional Resistor] – Complicated moving mechanism and daily wear and tear finally caused drifting. Even new sensors cannot be 100% balanced. Calibrating in controller settings might not work. We packed 10x correction resistors to solve the potential problem in hardware level. Solder one or two paralleled tiny resistors onto the potentiometer at the opposite direction against drifting. It will help correct 3 to 5 degrees drifting [When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no reaction when clicking, or it wouldn't center after years of wear and tear. The OEM genuine repair parts ensure accuracy and prolong lifespan [Reminder of DIY] – With as many as 14 prongs, de-soldering and soldering the whole module takes serious skills. We suggest replacing the potentiometers first to solve most of the joystick problems. To desolder the entire joystick module off PCB by a normal soldering iron, please take a look at the desoldering kit at product ID: B0BK7169M8, Platforms: Xbox One