|
ANYCUBIC Silk Filament, Clog-Free Shiny 3D Printing PLA Filament 1.75mm Dimensional Accuracy +/- 0.03mm, 1KG Spool (2.2 lbs), Silk White - HSCWH-10-US
ANYCUBIC HSCWH-10-US
-
ใ๐๐ฅ๐๐๐ฆ๐ข๐ง๐ & ๐๐ซ๐๐ฆ๐ข๐ฎ๐ฆ ๐๐ฎ๐๐ฅ๐ข๐ญ๐ฒใ A silky touch and a long-lasting shiny glow with fewer visible layer lines, leaving a soft touch and an astonishing look to all your prints. The 3D Printing Silk PLA filament was neat on the roll and left the spool easily without any crossed turns. ใ๐๐๐๐ฎ๐ซ๐๐๐ฒ & ๐๐จ๐ง๐ฌ๐ข๐ฌ๐ญ๐๐ง๐๐ฒใ Anycubic 3D Printer PLA filament of 1.75mm diameter, Minimum dimensional tolerance ยฑ0.02mm, which makes filament outflow smoother, came out homogeneous. The low shrinkage and stable printing dimensions make the fusion between the layers very good to obtain an even better-bridging result. You don't worry the diameter changes a lot then the feed rate is disrupted with thicker and thinner layers at all. ใ๐๐ฅ๐จ๐ -๐
๐ซ๐๐ & ๐๐ฎ๐๐๐ฅ๐-๐
๐ซ๐๐ใ Designed and Manufactured with a Clog-Free patent to guarantee a smooth and stable printing experience with our PLA refills. Completely dried for 24 hours before packaging and vacuum sealed with desiccants in nylon re-bag enable much smoother and more stable printing. The larger spool inner diameter design makes feeding smoother. ใ๐๐ฅ๐จ๐ -๐
๐ซ๐๐ & ๐๐ฎ๐๐๐ฅ๐-๐
๐ซ๐๐ใ Designed and Manufactured with a Clog-Free patent to guarantee a smooth and stable printing experience with our PLA refills. Completely dried for 24 hours before packaging and vacuum sealed with desiccants in nylon re-bag enable much smoother and more stable printing. The larger spool inner diameter design makes feeding smoother. ใ๐
๐ข๐ฅ๐๐ฆ๐๐ง๐ญ ๐๐ง๐ฌ๐ญ๐๐ฅ๐ฅ๐๐ญ๐ข๐จ๐งใ 1. Install the spool on the spool holder of a 3D printer, and preheat the nozzle of the 3D printer. 2. Cut the filament tip diagonally, and guide it through the extruder and feeding tube. 3. Manually push the filament through the feeding tube to the nozzle, until the filament melts through the nozzle. Note: When installing and changing filament, we highly suggest preheating the nozzle first to reduce the nozzle block risk.
|