Bike Trainer Stand fits 24” to 29” Bikes - Portable Magnetic Bicycle Rollers 5 Resistance Levels, Noise Reduction - Stationary Exercise for Road & Mountain Bikes - CXWXC

• 【Indoor Bike Trainers】: One of the problems with cycling, is that when the weather gets bad, conditions can keep you off the road or trail. Maybe it is raining or is too windy outside, or perhaps you need to avoid rush hour traffic or an unsafe dusk ride. This is when you just mount your bike on to a bike trainer and get the exercise that you want, but at home. There is no reason why you can not exercise with your bike when the outside weather is bad. 【Fits 24” to 29” Bikes】: With our bike trainer 26-29 inch tires including 700c will work perfectly. On the bottom of the kickstand there are two holes(primary or secondary position). Primary position for 26”-29” wheel, secondary position for 24”-26” wheel. Choose the position for your bike. Attach magnetic unit to kickstand by threading the bolt through the holes. 【5 Level Resistance Adjustable】: The trainer includes a drive-by-wire device so that you can change the resistance from your handle bars directly. You can adjust the magnetic resistor and switch the 5 resistance levels in seconds to meet your requirements about resistance and speed. The magnetic flywheel features technology that creates the same resistance experienced when riding outdoors. 【Smooth & Low Noise Operation】: There is almost no sound on the wheels on the riding platform. It is recommended to replace smooth tires during cycling training to reduce vibration, reduce indoor resonance or add carpet under the stage. In some cases it will be loud with MTB tires. If you owned a MTB with rough tires, careful to buy. Because MTB tires will be loud with all bike trainers, no matter how expensive it is. 【Portable Folding Bike Trainer Stand】: This bike trainer is lightweight and folds up, making it easy to throw into a car for a race-day warm-up or tuck into a closet to keep it from getting underfoot. It just takes a minute to set it up, clamp your rear axle with the quick clamp and adjust the contact between the wheel and the polished roller. No need to use other tools, you can directly complete the installation and disassembly process by putting up or unfolding the stand.