Btree 3Pcs L298N Motor Drive Controller Board Dual H Bridge DC Stepper Robot Stepper Motor Control and Drives Module for Arduino Smart Car Robot Power UNO MEGA R3 Mega2560 - Btree-L298NMDLE-20231226001

• [Strictly Select Chip]This module uses L298N as the main driver chip, , built-in low on-resistance MOS switch, which has the characteristics of strong driving ability, low heat generation and strong anti-interference ability,can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors.The chip is available in a 15-pin package. [Two Enable Control Ends]Motor drive module contains two H-bridges with high voltage and high current full-bridge drivers, which can be used to drive DC motors, stepper motors, relay coils and other inductive loads, and is controlled by standard logic level signals. [Drive High Efficiency]Dual-channel H-bridge driver design, can directly drive two 3-30V DC motor, or one 2-phase stepper motor, one 4-phase stepper motor, working power up to 35v, high current can reach 3A MAX, continuous current is 2A, power up to 25w, which created higher efficiency. [Main Parameters]Drive voltage: 5V-35V, Drive current: 2A (MAX single bridge), Logical part of the terminal power supply range Vss :4.5-5 .5V.Logic current 0mA-36mA,The control signal input voltage range: 4.5-5.5V low 0V high.Maximum power consumption: 20W [Notes]If the 5V powered by L298N is powered by another power supply (that is, it is not shared with the power supply of the single-chip microcomputer), then the GND of the single-chip microcomputer and the GND on the module need to be connected together, only in this way that the logic signal from the single-chip microcomputer has a reference 0 point. The input pins of the on-board 5V regulator chip and the motor power supply drive terminal are turned on.