Titoe Airbrush Kit with Compressor Portable Cordless Air Brush Gun Set for Model, Nail, Tattoo, Cake Decorating（Power Display) - 11

• 🎁【Cordless Airbrush Kit with Compressor】 Without tangled cables! You can use this mini air brush almost anywhere.This airbrush kit can be used for model making, cake decoration, drawing camouflage contours, tattoo manicure, crafts,tattoos,nail art and more! 🎁【3 Air Pressures Up to 30 PSI】10PSI,20PSI and 30PSI.The higher pressure is capable of delivering a heavier coating more rapidly over a wide area.Long press for 3 seconds to switch on and off, short press to change the air pressure. 🎁【0.3mm Fluid Tip】This gravity feed airbrush with 0.3mm needle and nozzle combination allows for finer control of liquid flow and less overspray. Note:Thick essence and paint may not spray out. Just need to make sure cleaned thoroughly after each use so nozzle doesn’t clog or not spray evenly. 🎁【Power Display】The upgraded power display can clearly see the amount of power. Don't worry about running out of electricity while it working.The airbrushkit comes with a type-c charging cable,you can access to power anywhere via computer charging, charger charging, or power bank charging 🎁【Removable&Easy to Clean】Our rechargeable airbrushkit is equipped with 5/20/40mL Cups and brush, simple to install or disassemble, satisfy your different demands.
• Name: Update V3.4 3-axis USB control card GRBL 1.1F. Input voltage: 12-24 VDC (24 VDC is recommended). Support software: GRBL Contol/Handle (3-axis)/General GCode Sender. Support system: Windows XP/7/8/10 Support software: GRBL Contol/Handle (3-axis)/General GCode Sender. Support system: Windows XP/7/8/10 supports XYZ three-axis control and spindle. Compatible with stepper motor: 12V, maximum current 2a or less, recommended within 1.5a, with additional heat. (any 42, 57 stepper motor). Support spindle: 24V2A, spindle PWM speed (0% - 100%). Main chip: Atmel 328P (Arduino Nano).